Dixon SpeedZTR ZTR 30 - Manual (Page 14)

14
SPECIFICATIONS
ZEETER 30”
CHASSIS: 11 gauge welded channel frame
BODY: All body parts made of rotational molded polyethylene.
Front body contains access panel for battery service.
Seat tilts forward to allow transmission service.
MOWER DECK: 11 GA stamped steel construction. Single 30” cut blade.
Cut height approximately 1-1/2”- 4” via 7-position lift
handle
BLADE DRIVE: Mechanical; hand lever engagement
TRANSMISSION: Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
ENGINE: 9 HP Briggs & Stratton Powerbuilt, 4-cycle, single
cylinder, air-cooled, gasoline, vertical shaft, aluminum
head and block.
STARTING SYSTEM: Electric by key switch operation with safety interlocks
on parking brake and blade drive.
TIRES: Front 9 x 3.50-4 Turf Saver
Rear 16 x 6.50-8 Turf Saver
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 3 quart
Engine 1.25 quarts oil
DIMENSIONS: Width 32” outside rear wheel measurement
Width 38” overall width of deck with deflector
Height 31” to top edge of seat
Length 65.5” hitch tab to front
Weight 390 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE