Daewoo DV3K683DZ-SD - Manual (Page 12)

19 Time Lapse Video Cassette Recorder 18 Time Lapse Video Cassette Recorder
To Cancel a Program Timer Recording
1 Repeat step 1 above.
2 Press the SHIFT (or ) button until the cursor is
located in the “Y” corresponding to the timer
recording to cancel.
3 Press the SET - (or +) button, to select “N”.
4 Press the MENU button three times until the normal
screen is displayed.
5 Press the POWER(STANDBY/ON) button.
• The clear button can erase the programmed timer
recording in the line that the cursor is located.
Notes...
• During timer recording all the buttons on the VCR, except
the STOP button, are disabled. If the STOP button is
pressed for three seconds during timer recording, the
recording will stop. During timer recording stand-by,
press the POWER(STANDBY/ON) button if the buttons do
not respond.
• If there is a power loss, the recording will be interrupted.
When the power is restored, the recording will resume if
the stop time has not yet been reached, and “
” will be
flashing on the display panel. The VCR internal battery is
completely charged after the VCR has been connected to
an AC power outlet for 48 hours, and it will maintain all
the VCR settings memory for up to 30 days.
• Set the timer recordings so that the recording times do
not overlap. If they do, the one with the earliest recording
start time will have priority.
(See chart below)
• If the cassette tape is ejected while timer recording is set,
the buzzer will be heard 5 times (when the buzzer
function is set to “YES”.)
Example 2 : To record everyday from 10 : 00 to 18 :
00, in 18-hour mode (recording speed)
1 Repeat steps 1 to 3.
2 Press the SHIFT button, until the cursor is on
“DLY”. The MENU below is displayed.
3 Repeat steps 5 to 13.
Programmed timer recording Example 2
Changing a Program Timer Recording
1 Press the MENU, SHIFT , SHIFT , SHIFT
buttons in sequence to display the TIMER PROGRAM
SET(1) menu.
2 Press the SHIFT (or ) button, until the cursor
is located in the setting to correct.
3 Press the SET - (or +) button, to correct the setting.
• Press the MENU button three times until the normal
screen is displayed.
4 Press the POWER(STANDBY/ON) button.