Delta 78-960 User Manual

Page 11

Fig.28

NOTICE: BEFORE MAKING ANY ADJUSTMENTS TO THE
GUARD BASKET ASSEMBLY, DISCONNECT THE SAW
FROM THE POWER SOURCE AND MAKE CERTAIN THE
SAW BLADE HAS STOPPED TURNING COMPLETELY!

26. Left to right movement of the blade guard basket (M)
Fig. 28, is obtained by loosening locking knob (H) and
sliding the T-Arm (J) to the left or right. Always tighten knob
(H) after adjustment is completed.

27. The blade guard mount bracket has a stop pin (K) Fig.
29 that engages hole (L) in the blade guard T-Arm. This is to
prevent the T-Arm from being completely pulled out of the
guard mount bracket (A). If the T-Arm must be removed from
the guard mounting bracket, loosen knob (H), slide T-Arm
(J) to the left until stop pin (K) engages hole (L). Pull pin (K)
and continue to slide the T-Arm out.

28. It is recommened that T-Arm (J) be waxed on a weekly
basis to allow it to move freely inside the guard mount bracket.
Meguiar’s M-2611 paste wax is recommended.

Fig.29

Fig.30

This manual is related to the following products:

78-955