Beurer MG 70 - Manual (Page 8)

8
2. Device description
A
B
C
D
E
F G
H
K
J
I
A Control (steplessly adjustable massage speed)
B sliding switch:
OFF
M – Massage
M+H – Massage and infrared heat
C Massage surface with infrared heat
D Fastening for hand strap
E Buttons to lock the handle
F Power cable
G Non-slip removable handle
H Exchangeable massage attachments:
- soft attachment
- nobbed attachment
I Massage head
J Hand strap
K Plug-in cover
3. Use
Purpose: The appliance is used solely for massaging the human body.
Decide whether you wish to use the massage device with its handle attached or without a handle, using
a hand strap. To remove the handle, press hard on the two retention buttons on either side of the handle
and pull the handle off the massage head. Insert the plug-in cover into the back of the massage head.
Put your hand under the hand strap. Using the Velcro fastener, adjust the length of the hand strap so
that you can hold the massage head in your hand and guide it safely.
If you wish to attach the handle again, first pull off the plug-in cover and reattach the handle until it is
heard to engage. The power cable emerges from beneath the handle retainer.
You can massage with or without the massage attachment. Simply choose the massage attachment that
you prefer. With M+H intrared heat treatment, any massage attachments will prevent the heat supply
of the infrared source. You should therefore only operate the device on ‚M‘ if a massage attachment is
fitted.
Make sure that the device is switched off before inserting the power cable. Switch on the device by
setting the sliding switch to
‚M‘ (‚Massage only‘) or
‚M+H‘ (‚Massage with infrared heat‘).
Set the required massage speed using the control. Place the device on the part of the body which you
wish to massage. You can stand up, sit down or lie down and you can either massage yourself or mas-
sage somebody else. Massage intensity can be varied by exerting more or less pressure on the massage
device. Never massage a specific part of the body for longer than 3 minutes without changing to another
area of the body. After using for a maximum of 20 minutes, switch off the device again, disconnect the
plug and let it cool down. Store the device in a dry place.