Beurer MG 240 - Manual (Page 14)

14
return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position
is reached, the device switches off.
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait
until it has returned to the initial position.
Note
• The device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.
8. Care and storage
CLEANING
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• The removable cover is machine-washable at 40 °C. Please follow the cleaning and care symbols
on the label which is sewn into the cover.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
CAUTION
• If you use the screw for transport locking, take care when using the device again that it is definitely
removed before switching on.
9. In the event of problems
Problem Cause Remedy
Massage heads
rotating at
reduced speed.
The load on the massage
heads is too great.
Reduce the contact pressure on the head.
Massage heads
only rotate in the
upper or lower
region.
The massage has been
activated for the limited
region.
Press the FULL BACK, UPPER BACK or LOWER
BACK buttons to change the massage region.
Massage heads
not moving.
Appliance not connected to
the power supply.
Connect the plug to the mains supply and switch
on the appliance.
Device not switched on. Switch the device on with .
Select the massage region.
Transport lock has not been
removed, the massage
mechanism is damaged.
Contact your authorized dealer or the service
address.
Overheating protection
tripped, device is damaged.
Contact your authorized dealer or the service
address.