beautypg.com

Care and storage – Beurer MG 250 User Manual

Page 14

background image

14

5. heating function

Press the HEAT button to switch on the heating function of the massage heads. The blue lights in the

massage heads change colour to red.

• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device

for longer can over-stimulate the muscles and cause tension instead of relaxation. The massage can be

finished at any time by pressing the button. Please note that on switching off, the massage heads first

return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position

is reached, the device switches off.

• If the device is stopped be pressing a massage area button twice, it also returns to the starting position

after 15 minutes and then switches off.

• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait

until it has returned to the initial position.

note

• The device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.

8. Care and storage

CLeanInG

WarnInG

• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the

device or accessories.

• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent

for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.

• Do not use the device again until it is completely dry.

Storage

If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry

place without weighting it down.

CaUTIOn

• If you use the transport lock screws, take care to remove these before starting the device when you

next use it.

9. In the event of problems

Problem

Cause

remedy

Massage heads

rotating at

reduced speed.

The load on the massage

heads is too great.

Reduce the contact pressure on the head.

Massage heads

only rotate in the

upper or lower

region.

The massage has been

activated for the limited

region.

Press the FULL BACK, UPPER BACK or LOWER

BACK buttons to change the massage region.

Press the NECK button to activate the neck mas-

sage.

Massage heads

not moving.

Appliance not connected to

the power supply.

Connect the plug to the mains supply and switch

on the appliance.

Device not switched on.

Switch the device on with .

Select the massage region.

Transport locks were not re-

moved. Massage mechanism

is damaged.

Contact your authorized dealer or the service ad-

dress.

Overheating protection

tripped, device is damaged.

Contact your authorized dealer or the service ad-

dress.

This manual is related to the following products: