Beurer BC 58 - Manual (Page 22)

22
Error Display/
Symptoms Possible Causes Correction
Er1 or Er2 Fail to detect
systolic/diastolic
pressure. Repeat the measurement.
Make sure that the cuff
is positioned correctly,
and that you do not move
or talk.
Re-insert the batteries if
necessary, or else replace
them.
Er3 or Er4 The cuff is too tight
or too loose.
Er5 The inflation pres-
sure is higher than
300 mmHg.
Er6 More than 160 sec
with cuff pressure
above 15 mmHg.
Er0 , Er7 ,
Er8 , or ErA
There is a system or
device error. Contact customer service.
See warranty section.
Unit does not
turn on when
the
button
is pushed.
Batteries have run
down. Replace the batteries.
Battery polarities
have been posi-
tioned incorrectly. Re-insert the batteries in
the correct position.
The unit is defec-
tive. Contact customer service.
See warranty section.
The display is
shut off Activate the display by
moving the touch screens
activation switch to ON.
The batteries are
almost empty. Replace the batteries.
Note: If the unit still does not work, contact customer ser-
vice. Please see warranty for service contact.
11. FCC Statement
NOTE: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in
a residential installation.
The equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.