Besafe iZi Comfort X3 ISOfix User Manual

Page 8

wash with similar colours

• It is NOT ALLOWED to mount the seat in a front

passenger seat WITH AN ACTIVATED AIRBAG.

• Install only with 3-point car belts, approved

to UN/ECE Regulation No. 16 or other

equivalent standards (28).

Warning: potential misuse

shoulder

belt

hip belt

(28)

Cleaning instructions

• The cover of the seat must be washed according to the

instructions on the inside of the cover (27).

• DO NOT use any aggressive cleaning products; these may

harm the construction material of the seat.

(27)

• Make sure that the harness straps are fixed in the right way,

after fitting the cover.

Removing the cover: alternative 2

Pay attention when you

remove the cover, as fitting

the cover is done in the

opposite way.

The cover of the head rest can be taken off

separately by disconnecting the hooks at the

backside and pulling off the fabric to the front.

(26)

Refit the cover

Pull the harness straps through the opening of the seat cover

and lock the harness buckle. Pull the crotch strap through the

opening of the seat part.

Pull the loops of the harness straps from the bottom of the

seat part through the openings to the hooks in the bottom

of the seat. Hook both harness straps on the metal belt

hooks and pull the straps firmly to ensure that they are

correctly installed.

Pull the head rest in the highest position. Mount the head rest

cover and connect the hooks at the back side. Pull the harness

straps through the holes. Connect the loose bottom part of the

head rest fabric with the plastic part under the head rest.

To remove the seat cover,

the harness straps must be

released at both sides. See

red circle. Start to take off the

lower seat part and unhook

both harness straps from the

metal belt hooks (26).

This manual is related to the following products:

iZi Comfort X3