Deutsche Telekom Teledat 400 - Manual (Page 10)

This table lists the types of Ethernet cable to use for connecting directly to a computer or to an
external hub or switch (if connecting more than four computers).
LAN 10/100M PORT ETHERNET CABLE TYPE
COMPUTER HUB/SWITCH
1, 2, 3 straight-through crossover
4 UPLINK button ”on“ (pushed in) straight-through crossover
4 UPLINK button ”off“ (out) crossover straight-through
The corresponding LAN LED on the front panel lights up when the Teledat Router 400 is on
and properly connected to a computer or a hub.
Power inlet 5 Volts DC/2.4A
WARNING! Only use the supplied power adapter.
Connect the round end of the power adapter to the port labeled 5VDC/2.4A on the rear panel of
your Teledat Router 400.
Additional Installation Requirements
1. 1. A computer with an installed Ethernet NIC (Network Interface Card).
2. 2. A DSL modem and an Internet account
10