Belshaw Adamatic BX4E Eco-touch Convection Oven - Manual (Page 8)

FG 189 ECO-TOUCH 26 x18 UL 3 TRAY Belshaw Adaamatic t full 03-12 RAC 8
5.0 INSTALLATION
Water Supply;
It is the customer’s responsibility to provide an appropriate water treatment system
that will supply water that meets the water specification listed on page 6.
The supply must be provided with a shut-off valve, pressure reduction valve and
pressure gauge.
• AMBIENT TEMPERATURES : -
Maintain ambient temperatures below 115°
F (40° C) around the oven.
• CLEARANCE:
Provide 2” (50mm) clearance at the back and sides of this oven and 10” clearance at the
top to allow adequate air circulation.
• INITIAL CLEANING:
Before using the oven for the first time, Carefully wipe the interior and exterior of the oven
thoroughly with a clean cloth soaked in warm soapy water.
• BEFORE USE:
Fix top sealing ring M189-01-02000 over top pipe with NSF approved silicone sealant.
(as seen on the next page in the illustration for stacking ovens)
• IF A STAND IS USED under the oven, it must be sealed to the oven using a
continuous bead of NSF approved sealant around the perimeter and attached by two
brackets M189-05-00900 (one each side) at the rear.
CLAMPING BRACKET
M189-05-00900
RIGHT SIDE
CLAMPING BRACKET
M189-05-00900
LEFT SIDE
NOTE
A RUBBER WASHER SHOULD BE
FITTED TO ENSURE A FULL SEAL
WITH WATER SUPPLY.
(Part Number A900-05-261)
OVEN
BASE
“NSF REQUIRES THAT THIS EQUIPMENT IS TO BE INSTALLED WITH ADEQUATE
BACKFLOW PROTECTION TO COMPLY WITH APPLICABLE FEDERAL, STATE AND
LOCAL CODES.”
BRACKET