Belshaw Adamatic AutoFiller Donut Injector - Manual (Page 10)

FG053 -JAMMER 22-08-14 Rev A14 10
8.0 OPERATING CONDITIONS
1.0 For best results the electronic jammer should be placed on a level surface
at a normal work top height.
2.0 All cleaning and operation instructions should be followed meticulously.
3.0 Never immerse the base console in water.
9.0 OPERATING INSTRUCTIONS
1.0 Plug the socket of the moulded cable assembly into the rear of the base console.
2.0
Insert the plug of the cable into a 13amp wall socket.
3.0
Press the green “ON” area (1) on the membrane panel and the display will show zero.
4.0
Clip actuator tray (2) to centre support bar (3).
5.0
Insert each nozzle (4) into the filler unit (5) with the flat of the plastic ring facing down.
When the nozzle has been inserted as far as the ring , twist it through 90 degrees.
6.0
Place the filled hopper unit against the rear wall of the base console.
Lower the unit into place.
If any difficulty is experienced in locating the hopper onto the drive, press blue
“FAST FORWARD” on the membrane panel to advance the digital display to any
number. Then touch the actuator tray to cycle the hopper drive which will allow the
hopper to drop into place.
The machine is now ready for use
1
5
4
2
3