Belshaw Adamatic TYPE K Depositors - Manual (Page 3)

CARE, MAINTENANCE, and CLEANING
INSTRUCTIONS for PLUNGERS and HOPPERS
The plungers and hoppers of your Type K are precision instruments built
from alloy steels and aluminum. They should be handled with care to
insure continued satisfactory performance.
When cleaning aluminum, selection of the right type cleaner is your most
important consideration. Any household dish washing detergent which
is safe for aluminum does a good job of cleaning and does not attack
aluminum. Strong Alkali cleaners, such as lye, soda ash, and tri-sodium
phosphate, will discolor or even corrode aluminum even in weak solu-
tions.
DO NOT HANDLE ROUGHLY or drop on hard surfaces.
DO NOT MIX with other utensils in the sink when washing.
DO NOT ALLOW TO RUST. Always wash parts thoroughly.
DRY COMPLETELY AND THEN LUBRICATE with mineral oil or liquid
shortening before storing or reinstalling in unit.
DO NOT FORCE the machine if it becomes jammed. Disassemble and
remove any obstruction to prevent damage to the plunger.
WASHING PLUNGERS AND HOPPERS BY HAND
Remove plunger from hopper. 1.
Use plenty of warm water. 2.
Add cleaner approved for aluminum in concentrations recom- 3.
mended by manufacturer.
Presoak to loosen stubborn or dried-on deposits.
4.
Use a non-scratching plastic scour cloth to remove soil and restore 5.
luster.
Rinse in clear hot water (170-190 deg.)
6.
Wipe completely dry. 7.
Dip plungers in mineral oil or liquid shortening to prevent rust and 8.
sticking.
©BELSHAW ADAMATIC BAKERY GROUP • 814 44TH STREET NW SUITE 103
AUBURN, WA 98001 USA • WWW.BELSHAW.COM • WWW.BELSHAW-ADAMATIC.COM 4
SPECIAL INSTRUCTIONS FOR THE CARE OF
PANCAKE PLUNGERS:
The pancake plunger must be disassembled and cleaned thor- 1.
oughly after every use.
Remove plunger – Using thumb lift up on Spring Cup Lock Assem-
2.
bly (K-11A), turn 180 degrees, plunger should release from handle.
Remove Cage Assembly (K-22A) by releasing Lock Spring.
3.
Remove Valve Assembly (K-20) from Cage Assembly (K-22A). 4.
Clean all parts in warm water with recommended detergents. 5.
Dry completely. 6.
Reassemble plunger. 7.
NOTE: O-Rings are not used on plungers for Type K
Depositors
TYPE K PANCAKE DISPENSER • TYPE K DONUT DEPOSITOR
TYPE K HUSHPUPPY DEPOSITOR • OPERATOR’S MANUAL • MN-1536 111010
5