Dell ESX MD3000I - Manual (Page 8)

Dell Inc Page 8
8. Select iSCSI software adapter under storage. You should now see your iSCSI Target
name listed.
Figure 8: iSCSI software adapter after initial configuration
9. Select Properties under storage adapters. Select Dynamic Discovery. Select Add.
Provide the IP address of the MD3000i and click OK. There may be a slight delay before
the process completes.
Figure 9: iSCSI software initiator properties window
10. Click Close.
6. Configure iSCSI storage on ESX Server
Connect to the ESX server/Virtual Center using VI Client and follow the steps below.
1. Go to the configuration tab and select Storage Adapters. Select the iSCSI Software
Adapter and click Rescan. The newly created iSCSI target and LUN should be visible
from the ESX server.