BECKHOFF M6330 - Manual (Page 4)

INDUSTRIE INDUSTRIE INDUSTRIE INDUSTRIE ELEKTRONIK ELEKTRONIK ELEKTRONIK ELEKTRONIK
Eiserstraße 5 / D-33415 Verl / Phone 05246/963-0 / Fax 05246/963-149
M6330 Control Unit Page 4
Wiring Instructions
- The upper row of keys is configured for 5 V operation as standard. Operation with 24 V is possible
without modification. It should be noted here that the working voltage is brought to contact 13/21 of the
changeover switch, and the related load is connected to the make contact 14 and/or to the break contact
22.
- All 4 contacts on the optional EMERGENCY OFF switch are accessible at the terminal strip. If, for a special
application, the 5 V supply at contact 13.0 is not desired, it can be disconnected by opening a soldering
jumper. The position of the soldering jumper on the board can be seen in the diagram on page 3.
The make contact 14.0 remains connected to input D0.0, while break contacts 21-22 are available and
without voltage.
II/O Lightbus Telegram Assignments
The two modules are to be connected in series. The output from module A is usually connected to the input
of module B. This means that module A is to be entered first in the S1000 software II/O setup.
The tables on the following page apply to both of the modules.
M6330 D0 D1 D2 D3
Inputs for keys 100 - 103 and 200 - 211 Outputs for lamps 100 - 103 and 200 - 211
Signal Function Signal Function
D0.0 Input key 100 D2.0 Output lamp 100
D0.1 Input key 101 D2.1 Output lamp 101
D0.2 Input key 102 D2.2 Output lamp 102
D0.3 Input key 103 D2.3 Output lamp 103
D0.4 Input key 200 D2.4 Output lamp 200
D0.5 Input key 201 D2.5 Output lamp 201
D0.6 Input key 202 D2.6 Output lamp 202
D0.7 Input key 203 D2.7 Output lamp 203
D1.0 Input key 204 D3.0 Output lamp 204
D1.1 Input key 205 D3.1 Output lamp 205
D1.2 Input key 206 D3.2 Output lamp 206
D1.3 Input key 207 D3.3 Output lamp 207
D1.4 Input key 208 D3.4 Output lamp 208
D1.5 Input key 209 D3.5 Output lamp 209
D1.6 Input key 210 D3.6 Output lamp 210
D1.7 Input key 211 D3.7 Output lamp 211