BECKHOFF M1600 - Manual (Page 9)

M1600 Parallel Input/Output Beckhoff II/O-System
Date : 8.8.94 Version : 2.0 Page 9 of 14
The following modul configuration is possible by setting jumpers 3 to 6 :
Fast Inputs M1600 (Interrupt Inputs)
Jumper 3 Fast input II3 :
If jumper connection betwenn port D0.3 and
XILINX II3 is established Fast input is activated
Jumper 4 Fast input II2 :
If jumper connection betwenn port D0.2 and
XILINX II3 is established Fast input is activated
Jumper 5 Fast input II1 :
If jumper connection betwenn port D0.1 and
XILINX II3 is established Fast input is activated
Jumper 6 Fast input II0 :
If jumper connection betwenn port D0.0 and
XILINX II3 is established Fast input is activated
Power Supply
There are the following connections for power supply :
(1) two pole plug connection for the controller (X10 Pin1+2)
(2) two pole plug connection for outputs (X20 Pin1+2)
( 16 outputs )
(3) two pole plug connection for inputs (X21 Pin1+2)
(16 inputs)
(4) two pole plug connection for ground (X22 Pin1+2)
(5) 2x two pole plug connection for 4 high current outputs (X30 Pin1+2 and Pin
7+8)
(6) 2x two pole plug connection for 4 high current outputs (X31 Pin1+2 and Pin
7+8)
The power supply of the 8 high current channels is potential seperated from the control locic
unit. Thus the +24VDC lines and the 0V lines are are connected seperately.
The +24 VDC supply is established by two two-pin connections.