2 slave software, Slave software, Figure 12) – BECKHOFF FC1100 User Manual

Page 14

Text mode
Original mode

Figure 12: Windows Device Manager

The EtherCAT Slave Controller (ESC) is now accessible by using the library TcHelper.dll.

3.2.2

Slave Software

In case that the SSC Tool is used create an FC1100 based project (selectable in the “new project
dialog”). Otherwise enable “FC1100_HW” in the file ecat_def.h.
Note: When using the FC1121 slave card, the settings for “FC1100” apply as well.

If the slave application is executed on a Windows 32-

bit platform, then the library “TcHelper” can be

used. For all other platforms/operating systems a new library needs to be created (refer to 2
Hardware).

This manual is related to the following products:

FC1121