Directed Electronics 563T - Manual (Page 22)

19 © 2 0 0 3 d i r e c t e d e l e c t r o n i c s , i n c .
valet take-over
The Valet ® Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
To perform Valet ® Take-Over:
1. Before turning off the engine, press and release twice
within 3 seconds on the transmitter (or press and release the
optional momentary switch). Then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
note: This feature will not work if the brake pedal is
being pressed.
➜