Baumatic BF555SE - Manual (Page 23)

4) Pull the door downwards towards the bottom of the appliance,
releasing the top of the door from the top hinge-pin. Place the
door somewhere safe from damage.
5) Unscrew the two screws on the top hinge
and remove it. Re-attach the hinge to the
opposite side of the appliance.
6) Remove the hinge-pin hole cap from the top of the door and
insert it into the existing hinge-pin hole in the opposite side,
thus exposing the new hinge-pin hole and covering the old hole.
7) Unscrew the plastic hinge-pin receiver from
the bottom of the door and relocate it to the
opposite side. There are pilot groves for the
screws on the opposite side.
8) Reposition the door back onto the appliance, slotting the door
onto the hinge-pin protruding from the top of the appliance.
9) Install the lower hinge on the opposite side of the bottom of the
appliance/door from which it was removed using the original
screws, completing the door reversal procedure.
10) You can then stand the appliance back to its upright position.
IMPORTANT: Check that the door opens and shuts correctly,
without fouling, after you have completed the door reversal
process.
After the door has been reversed, you should check
the door seal of the appliance. The seal should not
be creased or crushed; otherwise there will be a gap
between it and the inside of the door.
o
The seal must adhere properly all the way around the door.
o
If the seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
OR
23