Baumatic BF555SE - Manual (Page 21)

21
o
Positioning the appliance requires two people in order to avoid
injuries or damage to the appliance.
o
Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not feasible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
o
You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o
Place the appliance flatly and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, which
can be used to level the appliance.
o
Anything positioned above the appliance must allow sufficient
cooling of the condenser with an approximate gap of 3 cm. You
must leave a 2 cm gap to the rear of the appliance and 2 cm
either side of the appliance.
o
If you are placing another cooling appliance next door to this
product, then there must be a gap of at least 2 cm between the
appliances. This will help to prevent condensation from forming.
o
Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury.
Levelling the appliance
o
If the fridge is not levelled during installation, the door may not
close or seal properly causing cooling, frost or moisture
problems.
o
To level your fridge you may either turn the levelling foot
clockwise to raise that side of the fridge or turn it anti-clockwise
to lower that side.
IMPORTANT: This process should be carried by two people.
While one person adjusts the foot, the other should push
against the top of the fridge to take some weight off the
levelling foot. This makes it easier to adjust the levelling foot.