Baja Motorsports BR150-1 Assembly Guide - Manual (Page 16)

How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red positive (+) pole of the
battery.
(see figure 24)
2. Connect the black negative (-) cable to the black negative (-) pole of the
battery. (see figure 25)
Note: The red positive (+) cable has a larger diameter than the black
negative y cable.
3. Charging rate: Charge battery @ 0.7 Amps for
5 ~ 10 hours.
• After charging is complete, install securely all six battery caps (see
figure 26)
Preparing the battery:
· Place battery on level surface. Remove cap strip from top of battery.
(see figure 20)
Wear eye protection and rubber gloves for this step. Once battery
strip is removed, locate electrolyte in bottle and place over the six
openings. Press firmly down on bottle allowing the battery to pierce
the six in-line openings in bottle. Let electrolyte drain into battery until
bottle is completely empty. (see figure 21)
· Discard empty electrolyte container in a waste area that is inaccessible
to children and animals.
After filling let battery stand for at least 30 minutes before charging.
This allows the electrolyte to penetrate plates for optimum performance
and ensures longer battery life.
After 30 minutes the battery is ready for its initial charge. Place caps
loosely over battery cell holes (see figure 22)
Figure 20
Figure 21
Figure 25
Figure 24
Figure 26
Figure 22
Battery Installation
Eye Protection
Rubber Gloves
WARNING
The following procedure is very dangerous and should be performed with
the utmost care and attention. Wear protective eye wear, rubber gloves, and
have water available should electrolyte come in contact with skin or eyes.
KEEP ALL CHILDREN AWAY FROM THE AREA WHILE THIS PROCEDURE IS
BEING PERFORMED.
POISON – CAUSES SEVERE BURNS
Contains sulfuric acid.
Avoid contact with skin, eyes, or clothing
To prevent accidents, rinse empty container with water.