Baja Motorsports WR90 - Manual (Page 25)

RESUMPTION OF SERvICE AFTER STORAGE
1. Remove covering and wooden blocks used in storing vehicle. Change engine
oil if vehicle has been out of service for over 4 months.
2. Drain off the remaining atomized anti-rust oil from the fuel tank, followed by
filling it with fresh gasoline therein.
3. Prior to driving, all required check-ups must be made. It is better to drive it at
a low speed in an open area to test its performance before normal operation.
TABLE AND TORQUE OF FASTENERS
No. Fastener Torque (Newton/m)
(Foot/lb.)
1 Front wheel axle nut 35-45Nm (26-33 ft.lb.)
2 Rear wheel axle nut 50-60Nm (37-44 ft.lb.)
3 Nut for tightening upper joining plate of
front
fork with vertical tube
40-50Nm (30-37 ft.lb.)
4 Nut for fixing engine 20-25Nm (15- 18 ft.lb.)
5 Rear arm nut 35-50Nm (26-37 ft.lb.)
6 Exhaust silencer nut 20-25Nm (15-18 ft.lb.)
7 Bolt for tightening upper joining plate of
front fork with shock absorber
15-20Nm (11-15 ft.lb.)
8 Bolt for fixing footrest 20-25Nm (15-18 ft.lb.)