Baja Motorsports WR90 - Manual (Page 22)

DRIvE CHAIN LUBRICATION
1. Shut off engine
2. Add light amounts of machine oil or chain grease to driving chain. (Too much
machine oil or chain grease may cause splattering to occur.)
Attention:
The chain should be replaced when adjusting limit has reached it’s maximum.
ADJUSTMENT OF CHAIN
1. When chain adjustment is needed, loosen rear axle bolt .
2. Turn chain adjusting nuts on the left and right sides to adjust tension of the
chain and to align the marking of chain adjuster with the engraved lines in the
similar position on both sides.
3. Tighten rear axle bolt by a torque of 50-60Nm (37-44 ft.lb.).
4. Repetitively check tension of chain.
5. When rear wheel is changed in position and the chain adjusted, free operating
movement of rear brake pedal will be affected, which, therefore, should be
15-20mm
1/2” - 3/4”
Chain adjusting nuts
Rear axle bolt