Baja Motorsports WD400-U Assembly Guide - Manual (Page 10)

10
Figure 24
Figure 25
Figure 26
Figure 28
Figure 27
Red +
Black -
Battery bracket
How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red positive (+)
pole of the battery.
(see figure 24)
2. Connect the black negative (-) cable to the black negative
(-) pole of the battery. (see figure 25)
Note: The red positive (+) cable has a larger diameter
than the black negative y cable.
3. Charging rate: Charge battery @ 0.7 Amps for
5 ~ 10 hours.
• After charging is complete, press down firmly with
both hands to seat the caps, (Do not pound or
hammer). The battery is now sealed. (see figure 26 )
• Install battery into battery compartment. The battery
terminals should be facing the front (see figure 27)
• Once battery is firmly seated in battery compartment
attach the red positive wire to the red positive terminal
on the battery. (see figure 28)
• Then attach the black negative wire to the black
negative terminal on the battery.
(see figure 28)
• Install the battery bracket (see figure 28)
Battery Installation
WARnInG
neVeR ReMOVe THe STRIP OF CAPS
nOR ADD Any WATeR OR eleCTROlyTe.