Babycare TENS Obi TENS - Manual (Page 6)

Setting up your Obi TENS
Check you have the following contents:
• 1 x Obi TENS unit
• 1 x Pack of 4 self adhesive electrodes
(40mm x 100mm)
• 2 x Leadwires (1 for use and 1 spare)
• 4 x AAA batteries (2 for use and 2 spare)
• 1 x Carrying pouch
• 1 x Easy-release neck cord
• 1 x Instruction manual
The assembly stage
1. Slide open the battery cover on the back of the
unit to expose the battery compartment.
2. Insert 2 x AAA batteries according to the
diagram found in the battery compartment.
Replace the cover.
a) Take one of the mauve and white leadwires and
insert the white jack plug at the end of the lead
into the socket at the bottom of the Obi TENS
unit. (Save the other leadwire as a spare)
b) Now insert the red and white pins (at the other
end of the leadwire) into the sockets attached
to the sticky electrodes. You will see that the
lead wire is made up of 4 wires; 2 mauve and 2
white. Do not remove the electrodes from the
backing at this stage (see figure below). NB.
Each leadwire has a red and white pin at the
end. It makes NO difference whatsoever which
electrode they are attached to!
c) If you wish, attach the easy-release neck cord
which enables you to hang the Obi TENS from
your neck whilst in labour.
6
Insert a red and black pin
(at the end of the lead wire)
into each pair of electrodes.