Baby Lock Maria (Previous Model) (BL23A) Instruction and Reference Guide User Manual
Page 67
66
1. Draw threads from the spools and pass them
through the points from 1 to 6 .
Thread each thread separately so not to tangle the
two strings of thread.
q
Presser foot lifter
2. The threading paths from 1 to 4 are the same
as single needle.
3. Slip one of the threads into the needle bar thread
guide on the left, and the other on the right.
w
Thread guide
4. Thread the needles from front to back.
* Do not use needle threader with twin needle.
* When changing the sewing direction, raise the
needles and turn the fabric.
1
2
3
4
5
6
CAUTION:
* Turn off the power switch before changing the
needle.
* When sewing with the twin needle, test the stitches
on a scrap fabric before sewing on the actual fabrics.
* Do not set the stitch width at more than 2.5, or the
needle will hit the needle plate and the needle will
break.
P
attern selector:
D, G,
I – L
Presser foot:
Zigzag foot
Thread tension:
1–4
Twin needle:
2 LP -90 (2.0 mm left shank)
(Twin needle is optional)
Stitch length:
0.5–1 (Satin stitch patterns)
S.S. (Stretch stitch patterns)
Stitch width:
2.5
•
•
•
5
4
3
2
1
Twin Needle Sewing (Optional)
6
•
5
4
3
2
1
6
q
w