Baby Lock Grace (Previous Model) (BL40A) Quick Reference Guide - Manual (Page 19)

For other exciting projects like this one, visit our Web sites at www.totallystitchin.net and www.babylock.com
17
17. Adjust the stitch width, and turn the handwheel
to check if the needle enters into each hole in the
button. Lower the foot to hold the button in place.
The holes in the button should align with the slot of
the foot.
18. On a four-hole button, stitch the two holes closest
to you first and then slide the button so the needle
aligns with the remaining holes (Figure 3). Stitch
several times.
19. Repeat this process until all the buttons on the legs
are secure. Remember to raise the feed dog after
sewing.
20. To embellish the pockets, cut two strips of ribbon
the length of the pocket plus 1”. Fold the ends of
the ribbon under and glue or fuse (following the
manufacturer’s instructions) the ribbon to the top of
the back pockets.
21. Using a hand needle and thread or fabric glue,
place a button on both ends of the ribbon.
8. Thread the Baby Lock Grace sewing machine with
all-purpose thread.
9. Stitch the side seams of two of the cotton leg pieces
together forming a tube shape.
10. Fold over ½” and press the top edge of the cotton
piece.
11. Pin the lower cut end of the jeans leg and the cotton
leg piece right sides together. Stitch the lower leg
using a ½” seam allowance.
12. Turn the jeans wrong side out; press.
13. Glue or fuse (following the manufacturer’s
instructions) the upper edge of the cotton piece to
the inside of the jeans leg.
14. Repeat for the other leg. Turn the jeans right side
out. Fold up and press the lower edge 3” to form the
cuff.
15. Stitch 5 buttons to each leg,
3 on each denim side and
2 on each cuff. To sew the
buttons by machine, attach
the button fitting foot M
(Figure 1), select stitch 05,
and lower the feed dog on
the machine.
16. Place the button into the button fitting foot (Figure 2).
Fig. 1
Fig. 2
Fig. 3
Button 1