Baby Lock Diana (BL480A) Getting to Know Guide - Manual (Page 13)

11
3 While holding thread with fingers, pass it
between the tension discs and pull thread
down to make certain it is properly located in
between the tension discs.
4 &
5
Slip thread behind metal guide and
into rear slot on thread guide.
6
Pass thread into the slot of take-up lever
cover.
7
Position thread into the right guide
located at base of take-up lever cover.
8 Slip thread from left to right into the thread
guide located on bottom of the needle
clamp. Position the thread into the right
section of the guide.
Note: Before threading eye of needle, slip
thread behind thread guide located on the
bottom of the needle clamp.
9 Thread the eye of the right needle from
front to back. Draw about 10cm (4 inches)
of thread through needle eye toward the
rear of machine and place thread to the
back, under the presser foot.
Note: Use tweezers provided in the
accessory case to aid in threading
the needle.