Baby Lock Imagine Wave (Previous Model) (BLE3ATW) Instruction and Reference Guide - Manual (Page 46)

U
S
I
N
G
S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
44
Looper Threading Tool
B
A
1. Open the front cover and raise the presser foot.
2. At the threading port, cut the looper thread that is to be
replaced. Remove thread from under the foot and the upper
thread guides. Replace cone of thread with specialty thread.
3. With machine in locked position set the looper threading port to
U or L, according to the looper that is being threaded.
4. Thread specialty thread into the upper thread guides, leaving
an 18 inch (40cm) tail above the threading port.
5. Place the straight end of the looper threading tool into the
threading port. Push the looper threading tool until the end
comes out of the looper eye.
6. Insert the specialty thread tail into the looper threading tool eye
(fig.A). Pull the straight end of the looper threading tool through
the looper eye bringing the specialty thread with it. (fig.B)