beautypg.com

Dodge 2006 LX Magnum User Manual

Page 115

background image

2. Position the end of your hand-held transmitter 1-3
inches (3-8 cm) away from the HomeLink buttons.

3. Simultaneously press and hold both the HomeLink
button that you want to train and the hand-held trans-
mitter buttons. Do not release the buttons until step 4
has been completed.

NOTE:

Some gate operators and garage door openers

may require you to replace this Programming Step 3 with
procedures noted in the

ЉGate Operator/Canadian Pro-

gramming

Љ section.

4. The EVIC display will show “Channel X Training”
(where X is Channel 1, 2, or 3). Release both buttons after
the EVIC display shows “Channel X Trained”.

NOTE:

If the EVIC display shows “Did Not Train”

repeat steps 2–4.

5. Press and hold the just trained HomeLink button and
observe the EVIC display. If the EVIC display shows
“Channel X Transmit” (where X is Channel 1, 2, or 3),
programming is complete and your device should acti-
vate when the HomeLink button is pressed and released.

NOTE:

To program the remaining two HomeLink but-

tons, begin with

ЉProgrammingЉ step two. Do not repeat

step one.

NOTE:

If your hand-held transmitter appears to pro-

gram the universal transceiver, but your garage door
does not operate using the transmitter and your garage
door opener was manufactured after 1995, your garage

HomeLink Buttons

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

115

3

This manual is related to the following products: