Aviosys 9258S - Manual (Page 7)

IP POWER 9258 USER MANUAL
- 6 -
4. Hardware & Software installation
Before you star to use IP Power 9258, please follow the steps below
 Check the package to make sure the contents is complete.
 Prepare one Ethernet HUB or Router
 Check the voltage of the power supply to make sure it is AC 110-240 volt
 Please confirm the specification of your power cable.
 IP Power 9258S: for 220-250V, please use the 10A power cable.
 IP Power 9258T: for 100-120V, please use the 15A power cable.
Hardware installation
a) Connect the 9258 to HUB through network wire.
b) Connect the HUB or Router to the internet (either through DSL or Cable modem).
c) Connect the power adapter to the 9258.
d) Connect the power adapters of under control electric equipment to corresponding
out port of 9258.
1. Turn on your computer and the power adapter of IP Power 9258
＊
For 220-250V, please use power wire can support 10A current.
Max. Output current: (total) 10A, (individual) 6A.
Max. Output current: (total) 15A, (individual) 6A