Aviosys 9258W2 - Manual (Page 3)

3
Step 3 : Press One time ( short) the “ Reset button” of 9258W2 and then there is one long beep
which means the WPS function of 9258W2 enable .
Step 4: After few seconds , there are 2 beeps which means WPS connection successfully ( If WPS
connection fail, there is one long beep mean the connection fail. Please go back to step 2 and try again )
Step 5: Then please power reboot 9258W2 . There is one short beep in 45 seconds which means
9258W2 boot up successfully. Then please go to next section Software Installation to install the IP
Search software
“IPEDIT.exe” in CD .
 Connection by LAN –Network cable :
User can also use LAN - network cable to connect 9258W2 . Please refer following step to setup LAN
connection
Step 1: Connect the LAN cable to 9258W2 .The LAN cable should be connect to a Router.
Step: 2 : Connect power cable to 9258W2 and switch power on the 9258W2 . There is one short beep in
45 seconds after 9258W2 power up .The short beep means 9258W2 boot up successfully
Step 3 : Then please go to next section Software Installation to install the IP Search software
“IPEDIT.exe” in CD .