Avionics Innovations FPD 10 (Flat Panel Display) - Manual (Page 7)

INSTALLATION INSTRUCTIONS
NOTE
FOR TECHNICAL ASSISTANCE PLEASE CALL
760-788-2602 8:00 AM TO 5:00 PM PST.
ALL REPAIRS AND RETURNS ARE PROCESSED
THROUGH AVIONICS INNOVATIONS
ALWAYS FOLLOW PROPER INSTALLATION PRACTICES PER FAA ADVISORY
CIRCULARS (AC) 43.13B OR LATER FAA APPROVED REVISION.
1.
Select an appropriate location for the AI-10 FPD
A. A load and stress analysis of the installation location is nessecary to ensure
adequate structural integrity. It is the responsbility of the installer to ensure the
structure is adequate for the installation of this unit.
2. Mount the AI-10 FPD (Refer to Drawing attached to this manual)
3. Wire unit (Refer to Drawing attached to this manual)
A. Use RG59 for video signal. Do not split the video signal to the display. Spliting
the signal will result in a poor video signal for the AI-10 FPD.
B. Use 20G MIL-W-22759/16 wire for power and ground wiring.
NOTE
Hardware
All hardware shall be of an approved aviation standard type and appropriate backing
plates are to be manufactured for security of the panel.
Use appropriate AN or MS screws or bolts with washers to install your A1-10 FPD. The
monitor utilizes four mounting holes with nut plates on the back of the case to mount the
monitor to the interior of the aircraft. Four 10-32 screws are used to attach the monitor to
the structure. The lengths of the screws are determined by the thickness of the structure
the panel is being attached. Do not allow the screw or bolt to enter the back of the panel
any more than 1/2 inch as this could damage internal the monitor.
Revision NC 10/4/2002
Page 6
Avionics Innovations, Inc
AI-10 FPD Installation Manual