Avalon Firestyles Cottage - Manual (Page 32)

32
Optional Equipment
Travis Industries 93508113 4 020325
Rear Blower Installation (Part number 97000138)
The rear blower improves heat transfer by pushing heated air through the convection channel.
Operating instructions are described in the section "Blower Operation" on page 20.
1 The stove should be in place with the legs installed prior to installing the rear blower.
2 Follow the directions below to install the thermodisk.
Detach the air intake
cover and cover plate
to expose the air
channel underneath
the firebox. Replace
after installing the
thermodisk.
Phillips
Screwdriver
Wedge the snap disk directly in front of the
stiffener on the left side, away from air flow.
Twist the wires together and feed them through the
channel, out the hole at the back left of the stove
(see the illustration below).
a
b
c
NOTE:
Bend the legs on the
snap disk assembly to
insure a snug fit.
Snap Disk
Assembly
3 Install the wire clip following the directions below.
Slide the wire clip
over the edge of the
strip of metal between
the two knock-outs.
Feed the two snap disk wires into
the eye of the wire clip. Remove
all slack from the wire, making
sure not to dislodge the snap disk.
Pinch the eye of the wire clip to
secure the wires.
Wire Clip
Snap Disk
Wires
WARNING:
To prevent electrical shock, the
wires must be secured so they do
not contact the firebox above the
convection channel.