Avalon Firestyles Cottage - Manual (Page 30)

30
Listing Information
Travis Industries 93508113 4 020325
CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT
INSTALLATION AND RESTRICTIONS IN YOUR AREA.
LISTED SOLID FUEL BURNING APPLIANCE SUITABLE FOR USE IN
RESIDENTIAL, ALCOVE AND MOBILE HOME INSTALLATIONS.
PREVENT HOUSE FIRES - Install and use only in accordance with the manufacturer’s installation and operating instructions. Contact
your local building or fire officials about restrictions and installation inspection in your area. Refer to local building codes and
manufacturer’s instructions for precautions required for passing a chimney through a combustible wall or ceiling. Do not run a
chimney connector through a combustible wall or ceiling. Do not connect this unit to a chimney flue serving another appliance.
Clearances may be reduced by methods specified in NFPA 211, listed wall shields, pipe shields, or other means approved by local
building or fire officials. For use with solid wood fuel only (cord wood). Operate with feed door closed - open to feed fire only. Do not
use a grate to elevate fire - build fire directly on hearth.
DANGER: Risk of electrical shock. Disconnect power supply before servicing. Route power cord away from unit. Do not route power
cord over or under appliance.
DO NOT OVERFIRE - If heater or chimney connector glows, you are overfiring.
Inspect and clean chimney frequently - under certain conditions of use, creosote buildup may occur rapidly.
DO NOT REMOVE THIS LABEL
• DURAVENT model DVL with DURATEC chimney
• DURAVENT model DVL with DURA-PLUS chimney
• AMERI-TEC model DCC with model HS chimney
• SECURITY model DL with SECURITY model ASHT or S2100 chimney • GSW model Super Chimney Twenty-One connected directly to appliance
• SELKIRK METALBESTOS model DS connector with model SSII chimney
• ICC EXCEL (2100-2 Can.) (103-HT USA) chimney with HP connector
MODEL:
COTTAGE
TESTED TO UL 1482, ULC-S627, CSA B366.2
Room Heater, Solid Fuel Type - Also For Use In Mobile Homes
SERIAL
NUMBER
FREESTANDING INSTALLATION
CLEARANCE
REQUIREMENTS:
A. SIDEWALL TO UNIT
B. BACKWALL TO UNIT
C. CORNERWALL TO UNIT
D. SIDEWALL TO CONNECTOR
E. BACKWALL TO CONNECTOR
F. CORNERWALL TO CONNECTOR
STANDARD RESIDENTIAL
INSTALLATION (SINGLEWALL
CONNECTOR)
18.0”
18.0”
10.0”
27.75”
19.5”
19.0”
MOBILE HOME AND ALCOVE
INSTALLATIONS
(DOUBLE WALL CONNECTOR)
18.0”
11.5”
10.0”
27.25”
12.5”
18.5”
STOVE
NON-COMBUSTIBLE
FLOOR PROTECTOR
6"
MIN.
6" MIN.
16" MIN.
45˚
ST
OVE
ADJACENT WALL
ADJACENT W
ALL
F
C
STOVE
BACKWALL
SIDEW
ALL
E
D
B
A
MINIMUM CLEARANCES TO COMBUSTIBLES:
Report No. 028-S-33-2
10850 117th Pl. N.E. Kirkland, WA 98033
Manufactured By:
STANDARD RESIDENTIAL FREESTANDING INSTALLATIONS REQUIRE: 6” diameter, minimum 24 MSG black or 25 MSG blued steel
connector, with listed (type HT) factory-built chimney, suitable for use with solid fuels or masonry chimney. Do not install in a
sleeping room of a mobile home.
ALCOVE INSTALLATIONS REQUIRE: One of the Listed doublewall connectors listed below. Maximum alcove depth 48”, minimum
alcove height 84”, minimum alcove width 61-1/8”.
MOBILE HOME INSTALLATIONS REQUIRE: One of the Listed doublewall connectors listed below. Mobile home installations also
require outside air - use the Avalon optional outside air boot.
OPTIONAL EQUIPMENT: Rear Blower
Electrical rating: 115V, 60 Hz., 1.8 Amps
Replace glass only with AVALON supplied
ceramic glass (5mm).
U.S. ENVIRONMENTAL PROTECTION AGENCY
Certified to comply with July 1990 particulate emission standards.
DOUBLEWALL CONNECTORS
2000 2001 2002 Jan. Feb. Mar. Apr. May June July Aug. Sep. Oct. Nov. Dec.
DATE OF MANUFACTURE
0378