Avalon Firestyles 700 B-Vent-1994 - Manual (Page 31)

O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
P AGE 31
Surround Panels (Continued)
6. After the panels are in place, the trim can then be installed (the trim is optional).
Place the rounded edge of the trim that will be facing outwards when installed
face down (see the illustration below). Insert one small and one large "L" bracket
leg into the grooves in the 45
o cut end of each side piece. Slide the other leg of
each "L" bracket into the groove in each end of the top piece. With a screwdriver,
tighten the set-screw into the larger "L" brackets, insuring that the 45
o cuts are
butted together to form a neat joint. Pick up the brass trim and slide it over the
panels until the bottom of the trim is flush with the bottom edge of the side panels.
CROSS SECTION OF BRASS TRIM
Set-screw that
holds the larger "L"
bracket in place
Groove where the larger
"L" bracket fits into
Groove Where Top
Panel Fits Into
Groove where the smaller
"L" bracket fits into
Front Side
Larger "L"
Brackets
Top Trim
Smaller "L"
Brackets
Left Trim Right Trim
Insert
Lay the trim on
the floor in front of
the insert with the
rounded portion
facing down.
Telescoping Leg Installation
(Part number 99200120)
The telescoping legs are designed to support the front end of fireplace inserts on raised hearths.
It is adjustable from 4 5/8" to 7 1/2". It can be cut shorter by using a hacksaw (see the
illustration below).
1. Place the end caps into each lower segment of the telescoping legs (see the
illustration below).
2. Screw the telescoping legs together so the leg can be screwed into the bottom of
the insert. Hand tighten the telescoping leg into position.
3. While grasping the upper segment of the telescoping leg, unscrew the bottom
segment until it reaches the floor and supports the insert.
Adjust the
length of the
telescoping leg
by rotating the
lower segment.
Install the
telescoping leg
by tightening
the threaded rod
at the top of the
upper segment
into the bottom
of the insert.
If the telescoping leg needs to be less than 4 5/8", a hack saw
can be used to shorten its length. Seperate the two segments
and shorten both segments by cutting them with a hack saw.
The upper segment has a threaded rod inside. Do not damage
this rod while shortening the upper segment.
NOTE: The total length removed will equal the amount cut off of
both segments combined.