Troubleshooting eprom software – Auto-Zone Control Systems SS0070 USB-Link Technical Guide, Installation Instructions for the SS0070 USB-Link (Version 01D) User Manual

Page 16

Text mode
Original mode

USB-Link Technical Guide

Operator Interface

Troubleshooting EPROM Software

Verifying CommLink II, CommLink III,

and MiniLink EPROM Software Versions

In order to view controllers with the USB-Link on a networked sys-
tem, the CommLink II and III must have version 3.15 software or later
installed and the MiniLink must have version 3.14 software or later
installed. Please follow the directions to determine the current software
version.

NOTE:

If you purchased your CommLink II, III, or MiniLink

after January 1, 2007, there is no reason to check the
software version nor is it necessary to check the soft-
ware version of a CommLink IV.