Auto-Zone Control Systems SS0070 USB-Link Technical Guide, Installation Instructions for the SS0070 USB-Link (Version 01D) - Manual (Page 10)

USB-Link Technical Guide
10 Operator Interface
Prism II Setup Instructions
Confi guring Prism II for the USB-Link
1. Insert your Prism II software CD and follow the prompts to
install the software.
2. The software installation will install the Prism II
icon on your desktop. Click on this icon to open
your Prism II software.
3. Click the button and type in your
level 3 passcode (default is “9288”).
Click
.
4. If Prism II is online, click the
button to make it go
.
5. Click the button to open the Job
Sites Window.
6. Click on any empty location in the Job-Site Selection
Window and type in a job name in the Selected
Location fi eld. Press
.
Your job site name will now appear in the Job-Site Selec-
tion Window.
7. In the Serial Port fi eld, click on the pull down box and
select the COM port number that the USB-Link is using.
8. In the Type of CommLink selection box, select the radio
button next to USB Link.
9. In the Network Confi guration selection box, select the mode
for the USB-Link you are using. If using stand alone mode,
select USB Link Stand Alone. If using network mode, select
USB Link Network. The position of the slide switch on the
USB-Link must also be set to the mode you are using (See
Figure 3 on page 12 for help in setting this switch).
10. Click to close out of the Job Sites Window.
11. Click the button to go
.