Auto-Zone Control Systems Remote Link II Technical Guide, Installation Instructions for the Remote Link II Modem (Version 01C) - Manual (Page 15)

Remote Link II Technical Guide
15
Operator Interface
Prism and Prism II Setup Instructions for Alarm Call-Outs
Prism Setup for Alarm Call-Outs
1. Open your Prism software. Click on the
button and type in your level 3
passcode (default “sm”). Click .
2. If Prism is offl ine, click and
then click .
3. Click and then click
.
4. The CommLink Setup Window will appear. Click
. Type in the number of the
receiving cell phone in the pager fi eld.
Click
and then click .
5. In your cell phone entries, create an entry for each of
your job sites with its corresponding phone number so
that you know which job site has an alarm.
Prism II Setup for Alarm Call-Outs
1. Open your Prism II software. Click on the
button and type in your level 3
passcode (default “9288”). Click .
2. Click and then click
.
3. The CommLink Settings Window will appear. Click
. Type in the number of the receiving cell
phone in the cell/pager fi eld. Click and
then click .
4. In your cell phone entries, create an entry for each of
your job sites with its corresponding phone number so
that you know which job site has an alarm.