ATI Audio PPA-1 User Manual
Page 3
Audio Technologies Inc. Toll Free 800-922-8001 [email protected] www.
audio.com
CHARGING THE BATTERY PACK:
Plug the battery charger into the AC power source and connect charger DC plug
into the jack marked "Charger" located on the rechargeable battery pack. Mixer
should be OFF.
NOTES:
• The batteries will fully recharge within 3 to 6 hours
• The charger features fast current limited recharge (LED ON) switching to
constant voltage float mode (LED OFF). For complete recharging allow 1
to 2 hours in float mode after charger LED goes out.
• NOTE: Mixer can be operated while using charger, however recharging
time will be greatly increased. Mixer should be switched off to allow
recharge cycle to complete.
CAUTION: PLEASE DISCONNECT THE POWER SUPPLY CABLE FROM
MIXER WHEN NOT IN USE TO AVOID DRAININGTHE BATTERIES.