ATI Audio PPA-1 User Manual
Page 2
Audio Technologies Inc. Toll Free 800-922-8001 [email protected] www.
audio.com
PPA-1, PPA-2 and PPA- B Mounting Procedure
PARTS LIST:
1 ea. ATI #20761-501, -502 or -503 PPA-1, -2 or -3 as ordered
4 ea. 4-40 x 3/16 panhead screws
4 ea. #4 split lock washers
1 ea. 24VDC battery charger with interconnect cable
NOTE: the PPA-1, PPA-2 or PPA-3 assembly mounts directly to the underside of
the NANOAMP Series mixer. The PPA utilizes 2 ea. 12 VDC Power Sonic PS-
1208 or equivalent lead acid batteries.
INSTRUCTIONS:
1. Position PPA to the underside of the mixer; make certain that the
CHARGER jack on the PPA faces the front panel of the mixer.
2. Secure the PPA with 4 ea. 4-40 x 3/16 screws and #4 lock washers to the
mixer.
3. Insert the 24VDC OUT cable located at the rear of the PPA to the 24 VDC
IN receptacle located in the rear panel of the mixer.
INSTRUCTION - Rechargeable Battery Pack
1. The 24VDC output cable from the rechargeable battery pack is
disconnected from the mixer for shipping.
2. Please reconnect the cable to 24VDC mixer input.
3. Turn mixer power switch to "On" - front panel Power LED should light
Red.