beautypg.com

Ducati 999R User Manual

Page 7

background image

6

a. Use a hex driver to loosen the screws of the mount on the side of the body frames.

b. Install the supplied side guard wire into the mounts and re tighten the screws..

c. If you are unable to run the motorbike straight l, it may caused by improper set-up of the steering

servo linkage or the rear wheel may not be parallel to the front. To re-adjust the steering servo

linkage, repeat step 2a . To get the rear wheel parallel and achieve correct tension of the rear

drive chain, detach the 2.5mm screw on the rear end of the swing arm. Use you finger tip to feel

the best set-up of the tension of drive chain. The ideal set-up is around 2 mm range of

movement up and down. (Note: The rear tire and the swing arm must be parallel, if not, loosen

the 2.5mm screw on the right side of swing arm to parallel the rear wheel with the rear swing

arm.)

4

INSTALLING THE SIDE GUARD WIRE AND
ADJUSTING THE STABILITY

a

a

b

b

c

c

Detach the 2.5mm screw on the

rear end of the swing arm

Loosen the 2.5mm screw on the

right side of swing arm

Not Parallel

Parallel

After adjusting, tighten the

screw again.

Leave 2mm range of movement

up and down