Ducati 999R - Manual (Page 6)

5
3
INSTALLING THROTTLE/BRAKE LINKAGE
a a b b
c c d d
Skip if already assembled in RTR version
a. Build the throttle/brake linkages as shown in the diagram.
b. Install the kinked linkage end onto the carburetor lever, and secure the disc brake wire onto the
pivoting linkage collar with 1.5mm set screw.
c. Install the throttle servo horn onto throttle servo output shaft.
d. Secure the disc brake wire onto the brake lever on the rear disc brake with a 1.5mm set screw.
Optional Front Disc Brake (Purchase separately)
a a
b b
a. Build the front disc brake as shown in the diagram. Use a 3 mm hex wrench to detach the right
front plastic disc brake off the front forks.
b. Mount the disc brake and brake pad where the plastic disc brake is mounted. Sandwich the brake
disc between the brake pads. Secure the disc brake wire onto the pivoting linkage collar with
1.5mm set screw.
c. Route the disc brake wire through the supplied steel spring tubing and the vented window section
on the chassis frame. Secure the disc brake wire onto the brake lever and a linkage collar on the
front disc brake with a 1.5mm set screw.
Apply CA Glue
on the outer brake pad
Apply CA Glue
on the inner brake pad
c c