Dixon SZ4619 CA - Manual (Page 38)

mAINTENANCE
38
WARNING!
The machine must be standing
absolutely still when the park brake
is engaged.
Visually check that no damage is found on the lever,
linkages, or switch belonging to the parking brake.
Perform a stand still test and check that there is a
braking action.
To adjust the parking brake, contact the Dixon service
workshop.
Parking Brake
WARNING!
Faulty adjustment can cause an
accident.
8058-092
Released parking brake
Pump Belt
Replacing EZT (E-Series Zeroturn Transaxle) belt
Park the mower on a level surface. Engage the
parking brake.
EZT Belt Removal
NOTE: To maintain efficient cooling and not damage
the EZTs, be careful of the fan blades when servicing
the belt.
Remove the deck belt (see • Deck Belt Removal
in this section of the manual).
Create slack in the belt by removing the spring
•
on the pump idler arm.
The belt should now be able to be removed
•
from the engine pulley and EZT pulleys.
EZT Belt Installation
Wrap the EZT belt around the EZT pulleys •
Route the belt around the inside of the idler •
pulley.
Wrap the belt around the engine pulley.
•
Reattach the spring on the pump idler arm. •
Install clutch onto engine shaft (pulley side •
down), making sure key is installed. Align
the clutch anti-rotation tab into slot on clutch.
Secure clutch, install wire.
Reinstall the deck belt onto the electric clutch
•
(see Deck Belt Removal in this section of the
manual).