ART Pro Audio SLA4 - 4x140W Power Amplifier - Manual (Page 18)

SLA-4 SPECIFICATIONS
Dimensions 1.75”H x 19.0” W x 13.5”D
44.5mm x 482.6mm x 190.5mm
Weight 19.8 lbs., 9.0kg.
Input Connections ¼” TRS (balanced/unbalanced)
Euroblock (balanced/unbalanced)
Output Connections Multi-Way Binding Post
Input Impedance 44k ohms (balanced)
22k ohms (unbalanced)
Input Sensitivity 1V for full power output into 8 ohms
Output Power, 8 ohms 4 x 100Watts/Channel RMS
Output Power, 4 ohms 4 x 140Watts/Channel RMS
Bridged Output Power, 16 ohms 2 x 200Watts/Channel RMS
Bridged Output Power, 8 ohms 2 x 280Watts/Channel RMS
Stable into 2 ohms (stereo), short term
4 ohms (bridge), short term
CMRR >60dB (typical @ 1kHz)
Frequency Response 10Hz to 40kHz, +/- .5dB
Hum and Noise >100dB below clipping
Total Harmonic Distortion (THD) <0.05% (typical)
Slew Rate >20V/uS
Damping Factor >100
Transformer Type Toroidal
Power Requirements 100VAC 50Hz 1000 WATTS (max.)
120VAC 60Hz 1000 WATTS (max.)
220VAC 50Hz 1000 WATTS (max.)
230VAC 50Hz 1000 WATTS (max.)
240VAC 50Hz 1000 WATTS (max.)
Export units configured for country
of destination.
ART maintains a policy of constant product improvement. ART reserves the
right to make changes in design or make additions to or improvements upon
this product without any obligation to install the same on products previously
manufactured. Therefore, specifications are subject to change without
notice.
© 2008 Applied Research & Technology
- 18 -