ART Pro Audio HPFX - Headphone Mixer/Amplifier - Manual (Page 8)

STEREO MIX INPUT
Connect your cue track or stereo signal that you want to monitor, into the Stereo Mix Inputs.
The jacks are configured such that if you have a mono signal, to monitor, just plug into the
Right input. If you have a stereo signal on a stereo jack (T.R.S.), then plug into the Left input.
Plug into both inputs if you have separate left and right cables. Signals at these jacks are fed
directly into the headphone amp mixer section only.
MICROPHONE INPUT AND THRU
The XLR Microphone Inputs are connected directly to the Mic Thru XLR jacks, so that your mic
signal passes directly thru to your mixer or preamp input. The HPFX “looks” at the signals on
these jacks for its own internal use, but does not modify them or provide phantom powering.
Your Mixer or preamp still acts as the final termination of the microphone and is still the
phantom power source, when needed, for condenser type microphones.
Fill in the following information for your reference:
Date of purchase ___________________
Purchased from ___________________
Serial number ___________________
- 8 -