beautypg.com

ART Pro Audio HQ15 - Pro Dual 15 Band EQ w/ FDC User Manual

Page 8

background image

8

10. POWER CORD

This cord is used connect the AC power source to your equalizer. CAUTION: Equipment for USA

installation includes a captive power cord with a three pin polarized plug. DO NOT REMOVE THE

CENTER GROUNDING PIN.

11. FUSE HOLDER

This fuse holder contains the AC primary fuse. This fuse should be replaced with the same type fuse

if it is blown. If they continuously blow, stop replacing fuses and refer servicing to qualified personnel.

CAUTION: After checking the AC supply voltage, be sure that the correct fuse is in the fuse holder -

0.6Amp for 100-103VAC, as well for 220-240VAC.

12. AC VOLTAGE SELECTOR

Set this slide switch to match yo ur line voltage supply. CAUTION: For new installations and portable

sound systems, or any situation in which the mains power is suspect, it is wise to confirm appropriate

voltage and line polarity BEFORE connecting the instrument to power source.

13. GROUND LIFT SWITCH

This switch is used to disconnect the signal ground from the mains and chassis earth ground. You

may set the switch to the LIFT position if ”Hum”, caused by a ground loop, can be heard at the

speakers.

14. INPUT/OUTPUT CONNECTORS

1/4 TRS

The TRS (Tip Ring Sleeve) connector is balanced and wired as tip = Hi (+), Ring = Lo (-), and Sleeve

= Ground.

CAUTION: Only one of these sockets can be chosen for audio connection at the same time.

XLR

The XLR input connector is balanced and wired as Pin 2=Hi (+), Pin 3=Lo (-), and Pin 1=Ground.

CAUTION: Only one of these sockets can be chosen for audio connection at the same time.

RCA PHONO

The RCA Phono input is unbalanced at the tip = Hi (+) and the Sleeve = Ground.

CAUTION: Only one of these sockets can be chosen for audio connection at the same time.