ART Pro Audio HeadAmp6 - 6 Ch. Headphone Amp - Manual (Page 12)

HEADAMP6 SPECIFICATIONS
Input Connections:
XLR-F balanced (2),
¼-inch balanced (9)
Output Connections: XLR-M balanced (2),
¼-inch balanced (2),
¼-inch stereo headphone (18)
Input Impedance: 40K Ohms Main,
10K Ohms Direct,
15K Ohms Aux In
Output Impedance: <12 Ohms Headphones
Maximum Input Level: +21dBu (all inputs)
Maximum Output Level: 150mW (600 Ohm Headphones)
500mW (32 Ohm Headphones)
150mW (8 Ohm Headphones)
Maximum Gain: 22dB
Signal to Noise Ratio: >90dB typical
THD: <.01% typical
Dynamic Range: >101dB typical
CMRR: >40dB
Phase Shift: <10 degrees, 20Hz - 20kHz
Power Requirements: 120VAC / 50-60Hz, or 230VAC / 50 Hz, 15 Watts
Dimensions: (HxWxD inch) 1.75 x 19 x 6
Dimensions: (HxWxD mm)
44.5 x 483 x 152
Weight: 5.3 lbs. (2.4kg)
Ref: 0 dBu = 0.775VAC RMS
ART maintains a policy of constant product improvement. ART reserves the right to make changes in design
or make additions to or improvements upon this product without any obligation to install the same on products
previously manufactured. Therefore, specifications are subject to change without notice.
www.artproaudio.com
12
E-mail: [email protected]
© 2010 Applied Research & Technology HA6-5004-101