ART Pro Audio EQ341 - Dual 15 band EQ User Manual
Page 9
9
REAR PANEL CONNECTORS & CONTROLS
POWER CORD
This cord is used to connect the AC power source to your equalizer. CAUTION: Equipment for USA
installation includes a power cord with a three-pin polarized plug. DO NOT REMOVE THE CENTER
GROUNDING PIN.
FUSE HOLDER, LINE VOLTAGE SWITCH & GROUNDING SCREW
This fuse holder contains the AC primary fuse. This fuse should be replaced with the same type fuse
if it is blown. If they continuously blow, stop replacing fuses and refer servicing to qualified personnel.
CAUTION: After checking the AC supply voltage, be sure that the correct fuse is in the fuse holder -
0.5Amp (500mA) for 95-125VAC, as well as for 220-240VAC. When changing the fuse, make sure
that the holder is seated securely. The position of the line voltage switch determines the line voltage
range and is labeled on the switch
GROUND LIFT SWITCH
This switch is used to disconnect signal ground from the mains and chassis earth ground. You may
set the switch to the LIFT position if ”Hum”, caused by a ground loop, can be heard at the speakers.