beautypg.com

Dish Network DISH 625 User Manual

Page 3

background image

Page 25

Receiver Back Panel

Digital Audio Out

The

D

IGITAL

A

UDIO

O

UTPUT

is for use with high-quality digital

sound decoding systems. Connect the

D

IGITAL

A

UDIO

O

UTPUT

with a Digital Audio Optical cable (available at consumer

electronics stores).

TV Antenna/Cable In

The

TV A

NTENNA

/C

ABLE

I

N

is used if you want the satellite

receiver to connect the tuner of the nearby TV to an off-air

antenna or cable TV system when the satellite receiver is turned

off or when using the TV/VIDEO button on Remote Control 1.

Use a coaxial cable to make this connection to an off-air antenna

or cable TV system. The

TV A

NTENNA

/C

ABLE

I

N

connection is

color coded black. Your nearby TV must be connected to the

C

HANNEL

3-4

output to use this feature.

TV2 Connections

The following connections provide menus and programming to the remote TVs.

These connections are active when the satellite receiver is in

Dual Mode

or in

Single Mode

with

Shared View

enabled.

CH 21–69 Out

The

CH 21–69 O

UT

connection provides good quality video and

stereo audio for the remote TV(s). Use a coaxial cable to make

this connection to your home cable system. Remote TVs

connected to the home cable system can receive programming

from this receiver output. The

CH 21–69 O

UT

connection is

color coded yellow.

Note

: When connecting to the home distribution (

CH 21-69 O

UT

)

coaxial port, you must meet requirements covered under FCC

Compliance in the Appendix. To meet these requirements, an in-line

coaxial attenuator has been included with your receiver and may

need to be installed using the following guidance:

• If connecting directly to a TV tuner port, you must install the

attenuator in the cable between the

CH 21-69 O

UT

port and the

TV tuner.

• If connecting to your in-home cabling system to distribute the

signal to a TV(s) in other rooms, in most cases you will not have

to install the attenuator for typical in-home cabling systems.

Tip: If you connect
a cable to the TV/
Antenna In port,
attach the black
cable sticker to the
cable near where it
attaches to the
receiver. The
stickers are
located inside the
front cover of this
guide.