Dish Network DISH 625 - Manual (Page 11)

Page 33
Connecting the Receiver to the TV(s) in Another Room(s)
8. Connect CH 21-69 O UT
on the receiver to your existing wall cable outlet
using a coaxial cable.
Note : If you do not have an existing in-home cable system, you will need to
run coaxial cable to each TV in other rooms. If this is too difficult, you may
want to contact a professional to do this installation.
9. Place the yellow sticker on the CH 21-69 O UT
cable near where the cable
attaches to the receiver. The stickers are located inside the front cover of
this guide.
10. Turn on the nearby TV (the TV that gets programming from the TV1
outputs).
11. Make sure the receiver's green TV1 indicator is on.
12. Select the Modulator Setup (MENU 6-1-5).
With the Modulator Setup screen displayed on the nearby TV, use Remote
Control 1 to do the following:
a. Under TV2 Out , select either Air (for off-air channel numbers) or Cable
(for cable channel numbers) based on what you wrote down in step 5.
b. Under TV2 Out , use the UP and DOWN ARROWS to change the
modulator channel to the one you wrote in step 5.
c. Select Done .
14. For some TVs, you must run a channel scan so that the TVs will find and
display the selected channel from the receiver. Run channel scan on all
remote TV(s), if available. See your TV user’s guide for instructions.
15. Confirm that you see a picture from the receiver TV2 output on your remote
TV(s).
• If your picture looks good, go to step 23.
• If your TV(s) do not have a picture or if it is not as clear as you would
like it to be, go to the next step.